Skip to content
Viking Repair Newton Newton, MA · answered 24/7

The work · Newton, MA

Viking Range Repair

Professional Viking ranges in Newton kitchens — 36- and 48-inch tops, dual-fuel and all-gas, often with a griddle or French top section. Ignition, burner performance and the oven under the same top.

Stainless and black gas range with the oven door open on an empty cavity, one burner cap lifted off the grates and a blue towel on the counter

How it gets described

The call, in the caller's words

  • One burner will not light while the rest do
  • Sparking continues after the flame is established
  • Oven under the range not reaching temperature
  • Knob turning loosely without changing the flame

On the visit

What actually gets measured

  • Manifold pressure at the regulator, cold and under load
  • Spark module output and flame sense on every burner
  • Oven igniter current draw — the number that decides whether the valve still opens
  • Low-flame setting burner by burner, and the orifice behind a lazy one
  • Knob shaft and valve stem for wear where a knob has gone slack

Three steps, same as every call

  1. 01

    The plate and the symptom

    Model and serial off the rating plate, plus what the appliance is actually doing. Half of these calls are narrowed to two or three candidates before anyone is dispatched.

  2. 02

    Measured, not guessed

    Gas pressure at the manifold, element and sensor resistance, cavity temperature against the set point, pump and valve behaviour on a dishwasher. Numbers, taken in your kitchen.

  3. 03

    One number, then the work

    Parts and labour quoted together and agreed before anything is opened. If the sensible answer is that the repair is not worth doing, that is the answer you get.

What it costs

$95

Flat service call. It covers the visit and the full diagnosis, and it comes off the bill in full if you approve the repair.

And where the repair itself usually lands

  • Igniter or burner assembly $290$610
  • Oven thermostat or heating element $230$780
  • Control board or touch panel $360$850
  • Dishwasher pump or control $280$1,250
  • Refrigeration fan or defrost system $290$750
  • Compressor or sealed-system repair $1,110$2,520

Parts and labour together, quoted before anything is opened. A comparable replacement appliance runs $7,170 to $12,390 before delivery, fitting or cabinetry, which is why most of these repairs are still the cheaper answer.

Reviews

4.9

out of 5

across 902 reviews

On range repair

  • Cold patch on the left of the griddle and a lazy burner beneath it. A blocked orifice and a warped plate. He cleaned one, replaced the other, and it browns evenly again.

    Stuart M.Auburndale

  • Sparking carried on clicking long after the flame had caught. A switch behind the knob was staying closed. He changed it, checked the others on the same rail, then wiped the front down before leaving.

    Bethany C.West Newton

  • Two burners were roaring rather than burning quietly. The regulator had drifted after the gas meter was changed. He reset the pressure, cleaned the caps, and the whole top sounds normal again.

    Imogen R.Newton Centre

Book it in

Viking range repair in Newton, from the model plate onward.

Flat $95 service call, credited against an approved repair. On the road 8:00 am – 8:00 pm, seven days; the line is answered 24/7.